Product Overview
This 4-pin brake light / stop light switch is designed for installation at the brake pedal assembly. It is proposed as a replacement for OE reference 7T4Z-13480-AA and the additional references listed below. Fitment is vehicle-specific: compare the OE number, connector, switch shape, VIN, and original-part photo before purchase.
Key Features
- 4-pin electrical connector
- Brake-pedal-assembly installation position
- Mechanical replacement switch for the brake-light / stop-light circuit
- Cross-reference support for Ford and supported Mazda applications
- VIN and original-part-photo fitment support available before purchase
OE Reference Numbers
| OE reference | Reference status |
|---|---|
| 7T4Z-13480-AA | Primary reference |
| 8T4Z-13480-A | Additional cross-reference |
| GL3Z-13480-A | Additional cross-reference |
| GEG1-66-490 | Additional cross-reference |
| 4838697 | Additional cross-reference |
Important: OE numbers are provided for comparison. A matching OE reference is necessary but may not be sufficient by itself; connector, switch shape, vehicle production date, and catalog fitment must also agree.
Confirmed Fitment Warning
This item is not a universal-fit switch. The vehicle families below are family-level guidance, not confirmation for every year, engine, trim, market, or production date. Mazda 3 fitment applies only where supported by supplied catalog evidence. Contact us with the VIN and clear photos of the original switch and connector before ordering if any detail is uncertain.
Supported Vehicle-Family Guidance
- Ford C-MAX II
- Ford Grand C-MAX
- Ford Escape II
- Ford Focus III Hatchback
- Ford Focus III Saloon
- Ford Focus III Turnier / Estate
- Ford Tourneo Custom Bus
- Ford Transit Custom Box
- Ford Transit Custom Bus
- Mazda 3 applications where supported by supplied catalog evidence
Common Symptoms
A brake-light-switch fault may be associated with one or more of the following symptoms:
- Brake lights do not illuminate when the pedal is pressed
- Brake lights remain illuminated after the pedal is released
- Intermittent brake-light operation
- Cruise-control disengagement or inoperation associated with the brake-pedal signal
Product Specifications
| Product type | 4-pin brake light / stop light switch |
|---|---|
| Primary OE reference | 7T4Z-13480-AA |
| Pin count | 4 |
| Connector type | 4-pin electrical connector; compare shape and keying with the original part |
| Installation position | Brake pedal assembly |
| Approximate dimensions | 4.33 × 1.57 × 1.57 inches — pending physical verification |
Package Contents
- 1 × brake light / stop light switch
Installation Note
Installation procedure and adjustment can vary by vehicle. Confirm the correct switch position and pedal engagement before use. Professional installation is recommended when the vehicle-specific procedure is unknown. Test brake-light operation before driving.
Diagnostic Disclaimer
Brake-light or cruise-control symptoms can have multiple causes, including wiring, fuse, lamp, module, pedal adjustment, and connector faults. Diagnose the circuit and confirm the original part number before replacing the switch. This listing does not guarantee that replacing the switch will resolve a symptom.
Warranty
Proposed 1-year limited warranty, consistent with the current listing. Warranty terms, eligibility, and exclusions must be confirmed against the store's published warranty policy before this proposal is approved.
Need Fitment Support?
Send the full VIN plus clear photos of the original switch, connector face, and visible OE markings. Fitment support is a comparison service and does not replace vehicle-manufacturer or authoritative catalog verification.